Here is another easier way to read Ford or JLR SID208 ECU using J2534 devices, pcmflash software and godiag adapters. Device used here: PCMTuner dongle (pcmflash software) Scanmatik pro 2 (or other J2534 devices, openport etc) Godiag GT100+ breakout box (will work with or without this breakout box, but it is good to check communication) Godiag ECU Boot GPT Adapter Procedure: Video reference: Step 1: Read Password (via OBD on bench) Connect j2534 with gt100 and godiag ecu adapter Connect SID208 with godiag adapter via jumper cable follow the wiring diagram attached below Power gt100 with 12v adapter Connect pcmtuner dongle with PC NOTE: Must press the switch on Godiag ECU adapter to read ECU. Run pcmflash software Select 07 module JLR or Ford SID208 model Read and Save password. Step 2: Read and write ECU Open ECU Connect ECU with godiag ecu adapter according to the previous wiring diagram Then solder the chip to the PCB board according...